Subscribe to Our Youtube Channel
Related Manuals for Weceleh WE-A640STX-M2
Summary of Contents for Weceleh WE-A640STX-M2
- Page 1 GAS COOKTOP Instruction Manual Please read this manual before the operation, and keep this manual for future use. TO RECEIVE ANY SERVICE PLEASE CONTACT WITH:support@weceleh.com;...
- Page 2 Thank you for choosing our gas cooktop. To use this appliance correctly and prevent any potential risk, it is important to read this instruction carefully. It provides information for a safe installation, use and maintenance. Keep this instruction in a safe place for future reference.
-
Page 3: Table Of Contents
Contents 1. IMPORTANT SAFETY INSTRUCTIONS..........04 2.DESCRIPTION OF THE GAS COOKTOP..........07 3. DIMENSIONS AND CLEARANCE............08 4.INSTALLATION OPTIONS..............09 5. USE GAS COOKTOP................11 6. KEEP GAS COOKTOP IN SHAPE............11 7. PRACTICAL ADVICE ................13 8. TROUBLE SHOOTING................14 9. BURNERS AND NOZZLE SPECIFICATIONS ...........15 10. VALVE & FLAME ADJUSTMENT.............16... -
Page 4: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Please Read all instructions completely and carefully. IMPORTANT: Save these instructions for local inspector’s use. IMPORTANT: Observe all governing codes and ordinances Note to Installer: Be sure to leave these instructions with the Consumer Note to Consumer: Keep these instructions for future reference. IMPORTANT: Check the leakage ac- cording to the installation instruction. - Page 5 A statement that: • The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psi (3.5kpa). The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5kPa).
- Page 6 Electrical supply: This cooktop features pilotless electric ignition for energy savings and reliability. It operates on a 120- volt, 60 Hz power supply. A separate circuit, protected by a 15-amp time delay fuse or circuit breaker is required. · A properly-grounded 3-prong receptacle should be located within reach of the cooktop’s four- foot power cord.
-
Page 7: Description Of The Gas Cooktop
DESCRIPTION OF THE GAS COOKTOP MODEL:WE-A640STX-M2 MODEL:WE-A950STX-M2 1. Triple ring wok burner: (12000btu) 2. Rapid burner: ( 10200btu) 3. Semi-rapid burner: ( 6000btu) 4. Auxiliary Burners:(3400btu) 5. Ignitor for Gas Burners (only on certain models) 6. Safety Device (only on certain models) - Activates if the flame accidentally goes out (spills, drafts, etc.), interrupting the delivery of gas to the burner. -
Page 8: Dimensions And Clearance
Make sure the sides of the opening are parallel and the rear and front cuts are exactly perpendicular to the sides. Make sure the wall coverings, countertop and cabinets around the cooktop can withstand heat (up to 200°F) generated by the cooktop. MODEL:WE-A640STX-M2 MODEL:WE-A950STX-M2 PRODUCT DIMENSIONS:23.2X19.7 in(59X50cm) PRODUCT DIMENSIONS:33.8X19.7 in(86X50cm) -
Page 9: Installation Options
INSTALLATION OPTIONS INSTALLING THE COOKTOP Remove the screws on the sides of the cooktop burner box. Use those screws to attach the side mounting brackets. Insert the cooktop centered into the cutout opening. Make sure the front edge of the countertop is parallel to the cooktop. - Page 10 POWER SUPPLY LOCATIONS Gas supply: These cooktops are shipped from the factory set for either natural gas or LP gas. Check to be sure you have the correct cooktop for the type of gas being used. The pressure regulator must be connected in series with the manifold of the cooktop and must remain •...
-
Page 11: Use Gas Cooktop
How to Use Your Gas hob The position of the corresponding gas burner is indicated on each control knob. Gas Burners The burners are different in size and power. Choose the most appropriate one for the diameter of the cookware being used. The burner can be regulated with the corresponding control knob by using one of the following settings: On those models fitted with a safety device The knob must be pressed for about 6 seconds until the flame is lighted and warmed up. - Page 12 these parts be rinsed thoroughly with water and dry them by blowing, It is a good idea to clean up any spills too. After glass hob working, the surface must be cleaned by a damp cloth to remove dust or food ⚫...
-
Page 13: Practical Advice
Practical Advice Practical Advice on Using the Burners For best performance, follow these general guidelines: Use the appropriate cookware for each burner (see table) in order to prevent the flame to reach ⚫ the side of the pot or pan; Always use cookware with a flat bottom and keep the lid on;... -
Page 14: Trouble Shooting
TROUBLE SHOOTING If you find the gas hob cannot work suddenly or cannot work properly. Before calling customer service for assistance, let us check what we can do. First of all, check and confirm there have no interruptions to the gas and electrical supplies, particularly, if the gas valves keeping turn on. -
Page 15: Burners And Nozzle Specifications
Burners and Nozzle Specifications Adapting the Gas hob for Different Types of Gas Burner Power Nozzle 1/100 Power Nozzle 1/100 (btu/hr.) (mm) (btu/hr.) (mm) Auxiliary (Small) (A) 3400 0.93 3400 0.56 Semi rapid (Medium) 6000 6000 0.73 Rapid (R) 10200 1.55 10200 0.96... -
Page 16: Valve & Flame Adjustment
Valve & Flame adjustment Valve adjustment Valve adjustment should be done with the control knob set at Burner ON saving flame position. Remove the knob, and adjust the flame with a tiny screwdriver (see below). To remove the knob to adjust the flame To remove the knob and panel to adjust the flame To check the adjusted flame: heat the burner at full open position for 10 minutes.
Need help?
Do you have a question about the WE-A640STX-M2 and is the answer not in the manual?
Questions and answers