Table of Contents
Advertisement
•
When cleaning the external surfaces of the shaver, do not use strong
detergents or other chemicals.
•
To dry, wipe the surface of the shaver with a dry towel. Do not use a
hair dryer or heater to dry the shaver.
•
The shaver head and neck assembly is designed to be detachable from
the shaver body. Simply pull upwards from the neck of the shaver for
easy release. To reattach the neck, align it with the neck attachment
cavity so that it clips back into position.
•
If your unit start pulsating, this can be simply resolved by applying a
very small amount of light lubricating oil onto each separate cutter
head whilst the unit is turned off.
•
Place a small drop of oil onto a fingertip and then touch the oiled
fingertip to each cutter head, gently wiping the oil onto the cutter.
Wipe any excessive oil off the surface of the cutters. Re-oil only as
required.
•
Hair clipper oil, sewing machine oil, or olive oil are all suitable for this
purpose.
Note: The cutter heads should be cleaned under running water after
each use.
SAFETY MODE
•
Your head shaver will turn itself off and enter safety mode if the
demand on the battery is too high. This can be because of inadequate
cleaning or excessive hair clippings in the hair pocket.
•
If this occurs, open and clean your shaver. The left and right charging
indicator lights will flash for ten seconds. After an additional 5 seconds
your shaver will reset itself and be ready to operate as normal.
8
Advertisement
Table of Contents
