Download Print this page

Instrucciones Importantes De Seguridad - KEUCO Plan 33097 1550 Series Instructions For Use Manual

Advertisement

Available languages

Available languages

Read all instructions before using
US
Button
Function
Washbasin lighting
• The washbasin lighting is switched on by
pressing the button when light mirror is
switched on.
• Pressing the button again switches the light
off.
When both lightings are switched off, the light
mirror also switches off.
Dimming the front, wall and washbasin
lighting
• Press the button when the light mirror is
switched on and hold until the desired bright-
ness or the end value has been reached.
The setting is stored and reproduced when
switched on again (only for connection type 1,
see fi gure 4 on page 12).
Setting the light colour cooler
• Press and hold daylight white button and the
light colour fades to cool white.
• Release when the desired light colour has
been reached.
The setting is stored and reproduced when
switched on again (only for connection type 1,
see fi gure 4 on page 12).
Adjusting light colour - daylight white (cool
white)
• Press button and the colour temperature sets
to 6500 Kelvin.
Setting the light colour warmer
• Press and hold warm white button and the
light colour fades to warm white.
• Release when the desired light colour has
been reached.
The setting is stored and reproduced when
switched on again (only for connection type 1,
see fi gure 4 on page 12).
Adjusting light colour - warm white
• Press button and the colour temperature sets
to 2700 Kelvin.
Replacement parts with order numbers, see page 14
and 15.
The light sources may only be replaced by the
manufacturer, its customer service or by an
equally qualifi ed person.
For information about warranty and mainte-
nance, see the enclosed Care Instructions
and Warranty Card.
Disposal instructions
This category of device does not belong in
the domestic waste, but must be disposed of
separately in accordance with the relevant
local national regulations.
4
or installing this product.
Lea todas las instrucciones antes
ES
de usar o instalar este producto.
INSTRUCCIONES
IMPORTANTES DE
SEGURIDAD
PELIGRO -
descarga eléctrica:
– Desenchufe siempre este mobiliario de la toma de
corriente antes de la instalación y limpieza.
ADVERTENCIA -
riesgo de quemaduras, incendios, descargas eléctri-
cas o lesiones para las personas:
– Desenchúfelo de la toma de corriente antes de
poner o quitar piezas.
– Es necesaria una supervisión estricta cuando este
mobiliario esté cerca o sea utilizado por niños,
inválidos o personas discapacitadas.
– Use este mobiliario exclusivamente para su uso
previsto tal y como se describe en estas instruc-
ciones. No utilice accesorios no recomendados
por el fabricante.
– Nunca utilice este mobiliario si tiene un cable o
un enchufe dañado, si no funciona correctamente,
si se ha caído o dañado o si se ha caído al agua.
Devuelva el mobiliario al centro de servicio para
su examen y reparación.
– Nunca deje caer ni introduzca ningún objeto en
ninguna abertura.
– No lo utilice en exteriores.
– No lo utilice allí donde se usen productos de aero-
sol (espray) o donde se esté administrando oxígeno.
– Antes de la desconexión, ponga todos los interrupto-
res en la posición de apagado. Desconecte también la
electricidad en el interruptor o en la caja de fusibles.
– Coloque siempre los artículos más pesados en la
parte inferior del armario y no cerca de la parte
superior para evitar la posibilidad de que el mobi-
liario vuelque.
– Cada superfi cie destinada a soportar una carga
debe tener una declaración correspondiente en
las instrucciones de uso que especifi que la car-
ga máxima prevista para esa superfi cie en libras
(kilogramos).
ADVERTENCIA -
– Este producto puede exponerte a productos quími-
cos como el Di(2-ethylhexyl)phthalate (DEHP), que
es conocidos por el Estado de California causar
cáncer . Para más información ve a www.P65War-
nings.ca.gov .
GUARDE ESTAS INSTRUCCIONES
Para reducir el riesgo de
Para reducir el
California Prop 65

Advertisement

loading