Flex FX5121 Operator's Manual page 11

WARNING
product damage due to a short circuit, never
immerse your tool, battery pack or charger
in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
This handy inspection light must be used ONLY with the battery packs and chargers listed
below:
2.5Ah 3.5Ah 5Ah
FX0111 FX0321 FX0121 FX0331 FX0221 FX0341 FX0231
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
BRIGHTNESS ADJUSTMENT (FIG. 7)
Your inspection light is equipped with a three-
stage brightness adjustment button, providing
different light intensities for your operation.
Press the on/off button briefly to cycle through
the three-stage brightness. Each press of the
button switches brightness to the next stage.
a. To turn the light ON, press the ON/OFF
button. The light will be turned on at maximum
brightness.
b. To switch to medium brightness, press the
ON/OFF button again.
c. To switch to low brightness, press the ON/
OFF button again.
d. To turn the light OFF, press the ON/OFF
button again (a fourth time).
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
If any parts are damaged
or missing, do not operate
Battery Pack
6Ah 8Ah
WARNING
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
10Ah 12Ah
FLEX
FX0411
Fig. 7
On/Off Button
-11-
Do not attempt to modify
this tool or create
To prevent accidental
starting that could cause
Charger
FLEX FLEX FLEX
FX0421 FX0431 FX0451