Preparing To Play; Connecting The Power Cord; Turning On The Power - Roland C-280 Owner's Manual

Classic organ

Hide thumbs Also See for C-280:

Table of Contents

Preparing to Play

Procedure

Turn off the [Power] switch located at the left of the panel.

Connect the supplied power cord to the AC inlet located on the

bottom panel, and then plug the other end into an AC outlet.

fig.01-01

NOTE

Be sure to follow the steps below when turning the power on or off. If this is not done in

the correct sequence, you risk causing a malfunction, or even blown speakers.

Procedure

Rotate the [Volume] knob toward the left to lower the volume.

Press the [Power] switch to turn on the power.

fig.01-02

Press

NOTE

Use only the power cord that was supplied with the C-280.

If you will not be using the C-280 for an extended period, unplug the power cord from the

outlet.

Press again

OFF

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is

required before the unit will operate normally.

Table of Contents