KitchenAid KUDP01IL Consumer Reference Manual page 10

Delay Hours
Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.
To delay the start (Model KUDP01IL)
1. Close the door.
2. Select a wash cycle and options.
Press DELAY HOURS 1 time for a 2-hour delay, 2 times for a
4-hour delay, or 3 times for an 8-hour delay start.The number
glows above Delay Hours. The dishwasher starts the cycle in
the selected number of hours.
3. Press START. The selected cycle and option lights will flash
once to tell you that the delay has started.
NOTE: To cancel the delay, press DELAY HOURS until no number
is lit.
To delay the start (Model KUDP01DL)
1. Open the door.
2. Select a wash cycle and options.
3. Press 4 HOUR DELAY.
You will see
showing in the display.
4. Close the door.
5. Press the Start pad. The display will flash once to tell you that
the delay has started.
NOTE: To cancel the delay, press 4 HOUR DELAY to turn the light
off or press the Start pad.
To delay the start (Model KUDP01FL)
1. Open the door.
2. Select a wash cycle and options.
3. Press 4 HOUR DELAY. The delay light will glow.
4. Press START.
5. Close the door.
NOTE: To cancel the delay, press 4 HOUR DELAY to turn the light
off.
10
Status Indicators
Follow the progress of your dishwasher with the Status indicators.
Sensing/Soak (on some models)
Your dishwasher senses the soil level on the dishes. Soil level
determines the length of some cycles, the amount of heat or water
added, and the cycle needed for the load. Soaks help loosen soils
on the dishes.
Sensing/Soak glows during the sensing and soak parts of the
cycle. Wash action continues while sensing occurs. Wash action
pauses during a soak.
Add a Dish (on some models)
After a cycle starts, you can add an item to your dishwasher while
Add a Dish glows. After the light turns off, items added to the
dishwasher may not be completely cleaned.
Water Heating (on some models)
Water Heating glows, and the cycle progression pauses,
whenever water is heated to a set temperature during a cycle.
Wash or rinse action continues as the water heats.
Clean
Clean glows when a cycle is finished. The light turns off when you
open and close the door or press Cancel.
Sanitized
If you select the SANI RINSE™ option, Sanitized glows when the
SANI RINSE™ cycle is finished. If your dishwasher did not
properly sanitize your dishes, the light flashes at the end of the
cycle. This can happen if the cycle is interrupted or the incoming
water temperature is too low. The light goes off when you open
and close the door.