Connecting Soundbridge To Ac Power; Vi. Using Your Remote Control; Vii. Establishing A Network Connection - Roku SoundBridge M1000 User Manual

V. Connecting SoundBridge to AC Power
If you plan to use an Ethernet connection, be sure the cable is plugged in to the unit. Plug the
power cord into the SoundBridge unit, and plug the other end into to a wall outlet. M500 users,
note that the end cap has a hole for routing your audio and power cables toward the back of
the unit.
Hint: There is no power switch to turn on SoundBridge. As soon as you plug in the power,
you should quickly see the welcome message "Roku SoundBridge." If not, please stop and
ensure that your power cable is connected properly on both ends.
Warning for M500 users: Be sure to disconnect SoundBridge from AC power (by
unplugging the power supply from the wall) before connecting or disconnecting any
cables or the CompactFlash Wi-Fi card. Always be sure to replace the end caps on the
unit before plugging in the AC power supply into the wall, in order to avoid abnormal unit
operation due to static discharge.

Vi. Using Your Remote Control

The SoundBridge remote control is an infrared remote, so it needs "line of sight" to
SoundBridge in order to operate. Point the remote in the direction of your SoundBridge,
and make sure that the IR receiver window is not blocked by another object..

Vii. Establishing a Network Connection

Note: Do not plug in an Ethernet cable if you plan to use your wi-fi network to avoid confusion
in the setup of the device. Also, if you plan to use an Ethernet connection, make sure the cable
is connected before powering up the device.
Wired Ethernet Network: After you have connected SoundBridge to your computer via a
switch/hub/router (or directly to your computer via crossover cable) and powered up the unit,
SoundBridge will auto-configure its network settings (using DHCP or AutoIP). There is nothing
you need to do. If for some reason you have trouble connecting to your network, select the
"System Configuration" option, then select "Show Wired Ethernet Status."
12
Section 1: Getting Started