Table of Contents
Advertisement
SURFACE MAINTENANCE
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive
detergent, or steel wool/scouring pads which will scratch and damage surface.
Do not use products containing chlorine bleach or orange cleaners.
For heavier soil use liquid degreaser.
After cleaning, you may use non-abrasive stainless steel polish/ cleaners, to polish and buff out the
stainless luster and grain. Always scrub lightly using a microfiber or clean cotton cloth and with grain.
CLEANING TIP
Fill residue cups 1/4 full with water after cleaning.
This will help prevent residue from drying and sticking on the cup surface.
REPLACING LIGHT BULBS
CAUTION: Light bulb becomes extremely hot when turned on.
DO NOT touch bulb until switched off and cooled. Touching hot bulbs could cause serious burns.
Make sure all power is turned off and bulbs are not hot.
Remove by turning bulb counter clockwise.
Note:Bulb does not unscrew; it turns 60 degrees, stops and falls out.
If bulbs are difficult to turn due to prolonged use, firmly attach suction cup included in
hardware package or use a rubber/latex glove and turn counter clockwise.
Replacement bulbs are available at specialty lighting stores. Purchase type 40W light bulb.
14
Advertisement
Table of Contents
