Table of Contents
Advertisement
Hearing
protection
Always ensure the generator is properly grounded to prevent electrical shock.
You must always ground the generator by the following method when using the generator as a
portable electrical source:
1) Drive a 3/4" or 1" copper pipe or rod into the ground close to the generator. The pipe/rod
must penetrate moist earth – the depth required will be dictated by local soil conditions.
Consult with an electrician.
2) Connect an approved ground clamp to the pipe.
3) Run a 10 gauge (items BRPG5500, BRPG8000, BRPG8000ES) or an 8 gauge (items
BRPG13000ES) wire from the clamp to the generator grounding post located on the
electrical panel.
4) Do not connect the generator grounding post to a water pipe or a ground used by a radio
system.
Item # 165601
Control panel
shown
Ground
If a licensed electrician installs the generator with a connection to your building's electrical circuit
for use as a back-up power system, grounding may alternatively be completed through the
building's grounding system. Ask your electrician. If the generator is not grounded through your
building's electrical system, follow the procedure above.
WARNING:
Operating the generator when it is not properly grounded can result in electrical shock.
Installation / Initial Set-Up
Generators can produce noise levels of up to 95 dB in close proximity,
which can be dangerous to human hearing with prolonged exposure.
Hearing protection may be required for persons working within 15-20 feet of
the running generator for an extended period of time.
WARNING:
Never attempt to attach ductwork to the muffler system to lower noise
levels. This could cause hot air deflection, heat build-up, and
increased exhaust back-pressure, resulting in possible exhaust leakage
or damage to the generator.
5. Grounding the Generator
Grounding
Post
Copper Pipe/Rod
10 or 8 Ga. wire
22
Advertisement
Table of Contents
