JVC HR-XVC1U User Manual page 11

Inserting Batteries
1
Open the battery compart-
ment cover in the direction of
the arrow.
Battery precautions
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the "–" end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
Remote control basics
• Press POWER to turn the DVD/VCR on or off.
• Make sure TV/VCR/DVD switch is set to VCR/DVD.
• Tap VCR CH + or VCR CH – to move through the channels one channel at a time.
• The VCR CH +/– and SET +/– are also used to navigate on-screen menu system.
• You can directly access specific channels using Number keys pad.
• Each press of VCR or DVD, switches the screen between the VCR screen (VCR mode) and the DVD screen
(DVD mode).
Operation
• Aim the remote control at the remote sensor and press control buttons
to operate.
• Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of Approx. 5 meters.
Change the custom code for remote control
If you operate this DVD/VCR with another JVC's VCR simultaneously arranging them side by side, the both
recorders will react to this remote control. In this case, you can change the remote control and DVD/VCR to other
frequency (" "). Then you can operate only this DVD/VCR with this changed remote control.
When you purchased, the DVD/VCR and remote control have been set to the frequency-"
Example: Change frequency to
Remote control:
While holding VCR,
press 2(code: b) of
Number keys. (in
case of code: A,
press 1)
NOTES:
• If the remote control has been set to b, the DVD/VCR also must be set to b. Otherwise, the DVD/VCR can not be
operated with this remote control.
• To reset to "A", repeat above procedure. However press 1 instead of 2.
2
Install two "AA" batteries (supplied),
paying attention to the polarity
diagram in the battery compartment.
SUB TITLE
SP/EP
POWER
TV PLAY ZOOM
VCR DVD
MODE
0
TIMER
OPEN/
DVD MENU MARKER RETURN
CLOSE
DVD/VCR:
In the POWER off mode,
SEARCH
ANGLE
MODE
TITLE REPEAT
A-B press and hold PLAY for
TV
POWER
more than 5 seconds. "b"
INPUT
will appear on the display
TV VOL and then disappear after
TV/VCR
approx. 4 seconds.
Remote control
3
Replace the compartment
cover.
Approx. 5 meters
".
PLAY STOP
OPEN/CLOSE
REW FF REC DVD
11