Advertisement
L I G H T I N G R E I M A G I N E D
This model is compatible with Smart Lighting controller.
When using 0-10V function, please turn the dimming knob
to EXT. Insert telephone wire into the jack of the track and
Smart Lighting controller, and then Dimming function on the
LED fixture is enabled.
•
Maximum of 120 units can be controlled by Smart
Lighting controller.
•
Simulate sunrise and sunset for dimming.
•
Turn off the device automatically following the setting
time and temperature. In & Out jacks included on the
track allows for multi-fixtures connected in parallel.
After installation, verify if installation was a success by cycling the lights on / off a few times, setting 'over
temperature shut down' to a low value like 85°F, and rubbing the temperature probe with your fingers, tricking
the Smart Lighting controller into an over temperature condition and shutting the lights off. Then leave the probe
alone, and after 10-15 minutes as recommended, the Smart Lighting controller should turn all the lights back on.
For detailed instructions, please refer to Smart Lighting controller operating manual.
PROBLEM
One or more fixtures are
completely off.
Broken cable or wire connecting controller to fixture
Dimming failure
LED will not come on.
SCOPE OF USE AND MAINTENANCE
• Comply with local installation regulations.
• Store the fixture in a dry and clean environment,
with an ambient temperature of -10°C ~ 50°C
and ambient humidity of less than 90% RH. It is
recommended that the fixture shall not stay unused
for more than six months. If it has stayed unused for
more than six months, please test to ensure fixture is
functioning at 100%.
• Please keep products safe. Avoid mechanical
pressure, excessive vibration and dropping the unit
during the process of assembly to protect the light
bar and track.
• Keep away from water, oil and organic solvent, or it
will reduce the efficacy and have the potential risk of
electric leakage.
www.ionlight.com | info@ionlight.com | Exclusively Distributed by GGen Distribution Corp.
P.3
www.ionlight.com | info@ionlight.com | Exclusively Distributed by GGen Distribution Corp.
XR-830W LED
0-10V DIMMING
CAUTION
TROUBLE SHOOTING
PROBABLE CAUSE(S)
Disconnect from power source.
or wire connecting fixture to fixture.
The power supply settings do not match with
local AC voltage and frequency.
• All equipment, devices and machines shall be
effectively grounded.
• Regularly check and clean the dust from LED array.
1. Disconnect from power supply before general
care.
2. Remove the dust from the light bar by using low-
pressure compressed air.
3. Clean the diode array with a soft cloth to prevent it
from being scratched.
4. Be sure not to touch the diode with your bare
hands, even after the fixture is disconnected from
power supply.
• It is recommended that you contact a licensed
POSSIBLE FIXES OR
CORRECTIVE MAINTENANCE
Make sure power is on and cables are plugged in.
Repair or replace any damaged cables if necessary.
Disconnect fixture from the power supply.
Check settings and correct if necessary.
electrician or an expert if any of the following
happens:
1. The cable or the plug has been damaged.
2. The unit has been exposed to rain.
3. Significant changes in the unit performance.
4. Fixture or light bar dropped and corner of its
enclosure got bent.
• There are no serviceable parts inside the fixture.
Opening the fixture will void its warranty.
Ionlight.com | Exclusively Distributed by GGen Distribution Corp.
Advertisement
