Advertisement
L I G H T I N G R E I M A G I N E D
The power rate of the light bars can function when the
external gear button is pressed to the corresponding gear.
It is recommended that you keep a mounting height of
8"-20"(20cm-50cm) above canopy for optimal light efficiency
* Don't peel off the protective paper until installed to prevent damage to diode.
* Be sure light bar and track are clean, and user shall wear cotton gloves.
1. FIRST TAKE THE FIXTURE OUT OF THE PACKING.
2. UNFOLD THE FIXTURE TRACK (FIG.A) AND PLACE IT
ON A STURDY AND FLAT SURFACE WITH THE DIODE
ARRAY FACING DOWNWARD (FIG.B).
ALWAYS COMPLY WITH LOCAL INSTALLATION
The fixture is suitable for indoor environment. Do not install
your fixture in wet or outdoor environment. Do not operate
the fixture close to combustible materials. The fixture will
get hot during operation. Do not touch the fixture during
or right after operation. Make sure the power cord does not
www.ionlight.com | info@ionlight.com | Exclusively Distributed by GGen Distribution Corp.
P.2
www.ionlight.com | info@ionlight.com | Exclusively Distributed by GGen Distribution Corp.
XR-830W LED
ASSEMBLY INSTRUCTIONS
CAUTION
STEPS
REGULATIONS AND CODES
Ionlight.com | Exclusively Distributed by GGen Distribution Corp.
and uniformity. Growers should regularly monitor the
temperature at the canopy level to ensure the height of the
fixture is appropriate, as canopy temperature and ambient
room temperature can differ.
3. ATTACH THE CARABINERS FROM THE ROPE RATCHET
(OPTIONAL) TO THE RING BOLTS (FIG.B).
4. HANG THE FIXTURE IN THE REQUIRED LOCATION.
touch any hot part of the fixture. Make sure the fixture is clean
and hanging correctly. The normal operating environment
temperature should be below 104°F. Exceeding the maximum
environmental temperature will stress electronic components,
which will lead to shorter lifetime and decreased reliability.
Advertisement
