Advertisement
11
APPLICABLE CONTROLS
A wired remote controller is necessary for this function. This function cannot be operate with a wireless
remote controller.
REQUIREMENT
• When you use this air conditioner for the
first time, it takes approx. 5 minutes until the
remote controller becomes available after
power-on.
This is normal.
<When power is turned on for the first
time after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Power
"SETTING"
on
flashes
<When power is turned on for the second
(or later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Power
"SETTING"
on
flashes
• Normal settings were made when the indoor
unit was shipped from factory.
Change the indoor unit settings as required.
• Use the wired remote controller to change the
settings.
* The settings cannot be changed using
the wireless remote controller, sub remote
controller, or remote-controller less system
(for central remote controller only).
Therefore, install the wired remote
controller to change the settings.
33-EN
Approx. 5 minutes
"SETTING"
Remote
goes out
controller is
available
Approx. 1 minutes
"SETTING"
Remote
goes out
controller is
available
Changing of settings of for
applicable controls
Basic procedure for changing settings
Change the settings while the air conditioner is not
working.
(Be sure to stop the air conditioner before making
settings.)
The display content for setting differs from that on
the former types of remote controller
(RBC-AMT21E/AMT31E).
(The number of CODE No. has increased.)
4
6
1 5
1
Procedure
Push
button and "TEMP."
simultaneously for at least 4 seconds.
After a while, the display fl ashes as shown in the
fi gure.
Confi rm that the CODE No. is [10].
• If the CODE No. is not [10], push
to erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote controller is
accepted for a while after
(While air conditioners are operated under the
group control, "ALL" is displayed fi rst.
When
is pushed, the indoor unit number
displayed following "ALL" is the header unit.)
(* Display content varies
with the indoor unit model.)
‒ 33 ‒
Installation Manual
1
3
2
button
button
button is pushed.)
Advertisement
