Prismplus Printer - Rimage Amigo II User Manual

PrismPlus printer

To align your PrismPlus printer, refer to the following instructions.
Required tools:
T 25 Torx screwdriver
5/32" Allen wrench
1. To power on the Amigo II, press the PrismPlus power switch and the Amigo II power switch.
2. Wait for the unit to complete the initialization.
3. Prepare the unit for alignment.
a. Manually move the lift arm to the top of the
Amigo II.
b. To place a disc in the lift arm, press the
disc up into the lift arm while pressing the
disc release button.
c. To open the print drawer, press the printer
button.
d. Close and re-open the door. This releases
the lift arm so you can manually move it.
4. Align the printer.
a. Slowly move the lift arm down until the disc just touches the print pad.
Printer
Button
Side to Side
Alignment
Print
Pad
110654_G
Gripper
Holding Pins
Maintain the Amigo II
Lift
Arm
Disc Release Button
Lift
Arm
7