RightWay RW550 User Manual page 5

4. Place the suction cup on the desired location on the
windshield or dash disc; push the locking lever towards
the base of the mount. The mount should stick to the
surface.
If your mount does not stick, make sure the area is
clean and dry, then try again.
5. Align the tabs on the holder with the slots on the Navigator cradle. Slide
together until you feel a firm click.
6. Adjust the holder to the best viewing angle by:
a. Loosening the adjustor dials
b. Moving the corresponding part to the desired position
c. Tightening the adjustor dials.
7. Align the grooves on the bottom of your unit with the tabs on the bottom
of the navigator cradle; gently push the unit into the cradle until the unit
clicks into place.
8. To remove the RW Navigator from the mount, gently push back the tab
on the top of the cradle until you hear a click releasing the unit.
to Detach the Mount
1. Pull the locking lever away from the base of the mount.
2. Grasp the pull tab of the suction cup and gently pull away from the wind-
shield or dash to break the suction.
caution!
It is illegal in Minnesota to attach anything to the windshield.
When using navigation aids in a vehicle, it is your sole responsibility to place,
secure and use these aids in a manner that will not cause accidents, personal
injury, property damage, or in any manner to
obstruct your view. You, the user of this product, are solely responsible for
observing safe driving practices.
User Manual
5