Advertisement
1.Front Grill
2.Blade Cap
3.Fan Blade
4.Guard Knob
5.Rear Grill
6.Oscillation Control
7.Control Switch
8.Motor Housing
9.Fan Base
10.Base Locking Screw
The motor housing and shaft are assembled.
Unscrew the base locking screw from the
shaft.
Insert the shaft through the hole in the centre
of the fan base and twist into position.
Secure the shaft to the base by locking into
place with the base locking screw.
Remove the blade cap and guard knob from
the motor housing.
Components
Assembly
Secure the rear grill onto the motor shaft,
using the 3 pins to align it, keeping the carry
handle at the top. Screw on the guard knob
to keep the rear grill in place securely.
Push the fan blade onto the motor shaft until
fully seated and secure with the blade cap.
Open the guard clips around the front grill
and put into position, to match up with the
rear grill. The hook on the front grill should
hook over the top of the rear grill. Close all of
the guard clips and tighten the safety screw
at the bottom of the guard.
Advertisement
