Table of Contents
Advertisement
Cleaning and maintenance
- To ensure the best results and longest product life, clean the product before and after each
epilation to avoid long-term build-up of hair and dust.
- Before you start cleaning, switch off and unplug the appliance to allow it to cool down.
- Use a soft, clean, dry cloth to wipe and clean the surface of the light exit mirror.
- Store the device in a dry, dust-free place at a temperature between 10 and 60° C (50 and 140°
F).
- Never wash the product or accessories in taps or dishwashers.
- Do not use steel sponges, abrasive cleaners (toothpaste, etc.) or corrosive liquids (gasoline,
motor oil, acetone, etc.) to clean the product. Note: If water does not clean well, you can add a
few drops of high-concentration alcohol (not more than 96%) to the water to moisten the cloth
and clean the above-mentioned parts.
Environmental protection When disposing of the product, do not throw it away with general
household waste, but send it to a designated recycling center.
VI. Troubleshooting common problems
This chapter describes the most common problems that may occur when using this instrument.
If you cannot solve the problem with the following information, please contact the customer
service center in your country.
* The instrument/power adapter becomes warm during use.
This is a normal phenomenon.
No action is necessary.
* I put the epilator on the skin and the number flashed, but the cooling fan started to run.
The overheat protection has been activated.
When the overheat protection is activated, the fan continues to run continuously. Do not turn
off the unit, wait for it to cool down for more than 15 minutes before further use.
*Flash ready] flashes, but the device does not flash when the flash button is pressed.
The device needs to be reset. Restart the device, turn it off and turn it on again.
* It smells bad when using the device.
You have probably not completely removed the hairs in the treatment area. These hairs may
burn and produce a bad smell.
Advertisement
Table of Contents
