Advertisement
◎
Digitally regulated output maintains constant brightness
◎
Reverse polarity protection, to protect from improper battery installation
◎
Anti-roll and anti-slip body design
◎
Tactical tail switch for momentary-on function
◎
Functional side switch for output selection
◎
Made of durable aircraft-grade aluminum
◎
Ⅲ
Premium type
◎
Toughened ultra-clear glass lens with anti-reflective coating
Operation Instruction
The tail switch is tactical switch, the side switch is functional switch.
ON/OFF
Tap the tactical tail switch to momentarily turn on the light, release it the light will go out.
Fully press the tactical switch to turn on the light constantly, press again to turn off the light.
Output Selection
With
the
light
Turbo→Low→Mid→High.
Strobe
With the light on, press and hold the functional switch for 0.5 seconds to enter into the
Strobe mode, click once again to return back to General mode.
Intelligent Memory Circuit
The flashlight memorizes the last brightness used in the General mode, the next time it is
turned on, it will recall that previously used brightness level.
Over-heat Protection
The flashlight will accumulate a lot of heat when it is working at Turbo. When the light is
overheated up to 65
stepped way to prevent the light from overheating.
Low-voltage Warning Function
If low voltage is detected, the flashlight is programmed to downshift to a lower brightness
level until to Low brightness level. When this happens at Low output mode, the flashlight
blinks three times every five minutes to remind you to replace the battery. To ensure normal
use, the flashlight will not turn off automatically and will work until the battery runs out
completely.
Battery Specifications
Type
hard-anodized anti-abrasive finish
on,
single-click
the
℃
or above, the flashlight will automatically adjust the output in
Dimensions
functional
switch
Nominal
Usability
Voltage
to
cycle
through
Advertisement
