Asus PRIME H310-PLUS R2.0 Manual page 11

M.2 socket 3
This socket allows you to install an M.2 (NGFF) SSD module.
• This M.2 socket supports M Key and 2242/2260/2280
storage devices.
• When a device in SATA mode is installed on the M.2 socket,
SATA_2 port can not be used. Due to the Chipset limitation,
when an M.2 device is installed in PCIe mode, the socket is
set to PCIe 2.0.
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of
the system setup information such as date, time, and system
passwords.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
2. Use a metal object such as a screwdriver to short the
two pins.
3. Plug the power cord and turn ON the computer.
4. Hold down the <Del> key during the boot process and
enter BIOS setup to re-enter data.
If the steps above do not help, remove the onboard battery and short the two pins again
to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
Intel H310 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
System panel connector (20-5 pin PANEL)
This connector supports several chassis-mounted functions.
USB 2.0 connectors (10-1 pin USB78, USB910)
Connect a USB module cable to any of these connectors, then install the module
to a slot opening at the back of the system chassis. These USB connectors comply
with USB 2.0 specifications and support up to 480Mbps connection speed.
RGB header
This header is for RGB LED strips.
The RGB header supports 5050 RGB multi-color LED strips (12V/G/R/B), with a
maximum power rating of 3A (12V), and no longer than 3 m.
Before you install or remove any component, ensure that the ATX power supply is
switched off or the power cord is detached from the power supply. Failure to do so may
cause severe damage to the motherboard, peripherals, or components.
ASUS PRIME H310-PLUS R2.0
M.2(SOCKET3)
CLRTC
PIN 1
1-3