REVELL Concerta IW65 Install Manual

Thank you for purchasing the Rough-In Bracket for your Revel® 6-1/2" In-Wall Loudspeaker. Follow
the instructions below to install the rough-in bracket. Please note that the bracket installation must
be done before the wall board is put up.
Step 1: Snap the two flat
wing sections onto the frame
as shown.
Step 3: Use the wire tabs to hold pre-routed speaker wires in
place. Ensure that no wire remains exposed on the front (wall
board) side of the assembly.
Step 4: After the wall board is installed, cut out the hole for the speaker using the inside cut-out of the
frame as a guide. The speaker wire can then be run through the opening in the wall board and attached to
the speaker system - refer to the Owner's Manual of the loudspeaker for more information on system
setup.
Harman Specialty Group
3 Oak Park Drive
Bedford, MA 01730-1413
USA
Revel Part No. 170-0095 | Rev 0 | 02/07
Revel® RIB 6W Rough-In Bracket
WIRE TABS
Step 2: Position the Rough-In Bracket/Wing assembly
between the wall studs so that the bracket is in the correct
position for the final speaker placement. Nail the assembly
into place, making sure that the nail heads are as flush
against the wings as possible.
Note:
Make sure that the wire tabs on the assembly are in the
back, so they are on the inside of the wall.
Tel 781-280-0300
Fax 781-280-0490
www.revelspeakers.com
Use the wing edge with
the two larger holes.
Customer Service
Tel 781-280-0300
Fax 781-280-0495 (Sales)
Fax 781-280-0499 (Service)
Installation
WIRE
TABS