Table of Contents
Advertisement
Appliance door
en
Refitting the shelf supports
The shelf supports are designed to fit on either the right-
or the left-hand side (not both).For each of the shelf
supports, make sure that the hooks at the back are at
the top.
First, push the shelf support into the middle of the
1.
rear socket ‚ until the shelf support rests against the
cooking compartment wall, and then push it back ƒ
(fig.
).
!
Then push the shelf support into the front socket „
2.
until the shelf support also rests against the cooking
compartment wall, and then press it downwards ...
(fig.
).
"
20
qAppliance door
W ith good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the
appliance door.
Main oven – Fitting and removing the glass
panels
To facilitate cleaning, you can remove the glass panels
from the appliance door.
Locking the appliance door
Open the appliance door fully.
1.
Open the two locking levers on the left and right
2.
(fig.
).
!
Close the appliance door as far as it goes (fig.
3.
Removing panels
Open the appliance door slightly.
1.
Press the left- and right-hand sides of the cover
2.
(fig.°
).
!
Remove the cover (fig.
3.
Lift out the outer panel (fig.
4.
carefully on a flat surface.
Lift out the inner panel (fig.
5.
carefully on a flat surface.
).
"
) and set it down
#
) and set it down
$
).
"
Advertisement
Table of Contents
