König HC-PS20, HC-PS21 - Body Scale Manual

Table of Contents

Description

Device Overview

Display
Set button	Press the button to switch on the device. Press the button to confirm the setting.
Up button	Press the button to increase the value. Press and hold the button to accelerate the process.
Down button	Press the button to decrease the value. Press and hold the button to accelerate the process.
Unit-of-measurement button	Press the button to adjust the unit of measurement: kilogram (kg), pound (lb) or stone (st).
Battery compartment	Open the battery compartment. Insert the battery (CR2032) into the battery compartment. Close the battery compartment.

Display Overview

	User memory code		Weight (kg/lb/st)
	Gender		Body hydration percentage (%)
	Age		Body fat percentage (%) Body muscle percentage (%) Body bone percentage (%)
	Body height		Calories (kcal)
			Fat status

"Lo"	Low battery	Replace the batteries.
"Err"	Overload	The person on the platform exceeds the maximum capacity of the body scale. Step off the platform to prevent damage.
"ErrL"	Low body fat percentage	The body fat percentage is too low.
"Errh"	High body fat percentage	The body fat percentage is too high.
"C"	Error	Step off the platform. Step on the platform to weigh yourself again.

Place the device on a stable, flat surface.
To switch on the device, press the platform with your foot.
Step on the platform. Place your feet evenly on the platform without moving. The display shows the measurement data.
Step off the platform. The device switches off automatically.

You must create a user profile in order to achieve accurate results. The device can store a maximum of 12 user profiles.

Press the set button to switch on the device.
Press the up/down buttons to select your body parameter (0-9). Press the set button to confirm.
Press the up/down buttons to select your gender (male/female). Press the set button to confirm.
Press the up/down buttons to set your height. Press the set button to confirm.
Press the up/down buttons to set your age. Press the set button to confirm.
Press the set button to switch off the device.

Press the set button to switch on the device. The display shows the parameters of the last user or the default parameters.
Press the up/down buttons to select your user profile.
Press the platform with your foot.
Press the up button to enter recall mode. The display shows your last test record. Press the up/down buttons to navigate through the test record.

Read the manual carefully before use. Keep the manual for future reference.
Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.

Use only the batteries mentioned in the manual.
Do not install batteries in reverse polarity.
Do not short-circuit or disassemble the batteries.
Do not expose the batteries to water.
Do not expose the batteries to fire or excessive heat.
Batteries are prone to leakage when fully discharged. To avoid damage to the product, remove the batteries when leaving the product unattended for longer periods of time.
If liquid from the batteries comes into contact with skin or clothing, immediately rinse with fresh water.

Do not use cleaning solvents or abrasives.
Do not clean the inside of the device.
Do not attempt to repair the device. If the device does not operate correctly, replace it with a new device.
Clean the outside of the device using a soft, damp cloth.