Health O Meter HDM770, HDM820 - Weight Tracking Scale Manual

KEYS AND ICONS

1. Step On Indicator
2. Weight Readout
3. Unit of Measure: Pounds (LB) or Kilograms (KG)
4. User Number
5. Memory Indicator
6. Difference in weight compared to previously saved weight

IF WEIGHING IN KG

1. Turn on the scale by tapping the bottom right corner of the platform.
2. Choose kilograms (KG) using the selector push button on the back of the scale.
   

USING YOUR WEIGHT TRACKING SCALE

Your scale includes a weight tracking feature which will show the user how much weight has been gained/lost from the previous weight reading.

1. Place the scale on a flat surface. A hard surface is best for maximum accuracy.
2. Step onto the scale and position your feet so that your weight is distributed evenly over the scale platform. The LCD display will flash " " several times for a few seconds before displaying your weight. Stand still while reading the display.
   NOTE: This scale offers both "Instant ON" (Step onto scale) or "Tap ON" (tap on lower right corner and wait for " 0.0 " for weight measurement). During the "Instant ON" weighing, if you see " ", the scale has recalibrated. Please step on the scale to weight yourself again. This model will save readings for up to two (2) users.
3. Step off of the scale and prepare to select a user number for weight tracking.
   NOTE: Your weight will be displayed for a few seconds and then the scale will begin cycling through user numbers (1 - 2).
4. Select a user number by tapping the lower right hand corner of the scale when the number appears.
   NOTE: Your current weight has now been saved under a user number.
5. After saving, the display will briefly show your previously saved weight (if applicable) and will then show the difference between your current weight and previously saved weight.
   NOTE: In order to preserve battery life, your scale will automatically turn off after a short period of inactivity.
   

REPLACING THE BATTERIES

This unit includes ONE (1) CR2032 battery. When "LO" appears on the display, replace the battery.

Removing the battery will not affect the recorded data.

Battery Replacement

1. Locate the battery cover on the back of the scale. Push the locking tab and pull the battery cover up.
   
2. Use the tip of a pen to loosen the battery. Hold the scale at an angle to allow the battery to slide out.
   
3. Insert one new battery with the + side facing up, and press it firmly into its slot.
   
4. Replace the battery cover.
   

NOTE: The Lithium coin battery(s) used in this product contains perchlorate material. Special handling may apply in California. Go to: www.dtsc.ca.gov/hazardouswaste/perchlorate for more information.

CARING FOR YOUR SCALE

Periodically wipe the scale surface down with a DRY cloth to remove dust.

Weight exceeding the capacity (350 LB/159 kg) may damage your scale. This product is designed for personal use only. Not for commercial or industrial use. This unit is not waterproof; avoid contact with excessive moisture.

TROUBLESHOOTING

If "E" appears on the display:

• The scale cannot detect a stable weight. Stand still while weighing.
• The weight has exceeded the scale's capacity (350 lb / 159 kg).

© 2010 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.