Advertisement
PLEASE READ 'LET'S TALK SAFETY' AT THE BEGINNING BEFORE USE
Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments,
or removing and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the
thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug
from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters
to fully dry before putting back into the vacuum machine).
• For best cleaning results, filters should be tapped over a bin every 4-6 uses to remove dirt and debris and washed
every 3 to 6 months (depending on the level of use).
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
Assembling your vacuum cleaner
Press both buttons
at the end of the hose
and push hose into
the hose entry point.
Fully unwind the power
cord. A yellow mark on
the cord indicates the
recommended cord length.
Do not exceed the cord
beyond the yellow mark.
Insert the hose grip into the
telescopic extension tube.
Plug in and switch the
unit on by pressing the
power button.
Getting started
Press the button on the
telescopic extension
tube and adjust to
required length.
Insert the other end of
the telescopic extension
tube into the floorhead.
When unwinding the
power cord always pull
out to the yellow marker
but no further.
CAUTION
Advertisement
