Bagging The Clippings - Toro Recycler 20956 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side-discharge chute is on the machine, remove it;
refer to Removing the Side-discharge Chute (page 12) before
bagging the clippings. If the bag-on-demand lever is in the
recycling position, move it to the bagging position; refer to
Operating the Bag-on-Demand Lever (page 10).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
1. Raise and hold up the rear deflector (Figure 14).
1. Notches
2. Rear deflector
2. Install the grass bag, ensuring that the pins on the bag
rest in the notches on the handle (Figure 14).
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps above.
Operating the Bag-on-Demand Lever
The bag-on-demand feature allows you to either collect or
recycle grass and leaf clippings while the grass bag is attached
to the machine.
•
For bagging the grass and leaf clippings, press the button
on the bag-on-demand lever, and move the lever forward
until the button on the lever pops up (Figure 15).
10
Figure 14
3. Grass bag pin (2)