PROLUMIA Pro-Fit + Photocell Operating Instructions Manual page 6

SELECTABLE COLOR TEMPERATURE
There are 2 choices of color temperature by different setting on the
surface of the LED light engine.
The switch can be found on the LED module and can be seen
when you have removed the protective cap.
SELECTABLE OUTPUT BRIGHTNESS
There are two choices of output brightness by different setting on the
surface of the LED light engine:
ON - 100% (standard)
1 - 50%
The switch can be found next to the LED module and can be
seen when you have removed the diffuser.
MOUNTING
1. Disassemble the diffuser with the supplied Allen key and open the LED panel.
2. Pull the power cord through the gasket.
3. Fix the fixture on the surface with screws.
(Pay attention to the direction. This is indicated by the "UP" marking on the base of the fixture.)
4. Connect the power cord on the terminal correctly.
5. Assemble the LED panel and diffuser.
Min. 18mm
4 Cable connection
MAINS POWER SUPPLY
6
Min. 45mm
ø6mm
40mm
www.prolumia.com
Brightness Brightness
PH2
Pay attention:
• With stone, do not drill into the
joint/edge of the stone
• Do not use a pneumatic hammer
drill in soft stone
• Clear the borehole from dust
Output Output
ø4mm
Rubber
Metal