Ariens Sno-Thro ST11528LE Owner's/Operator's Manual page 7

ASSEMBLY
Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge
Unfold Handlebar (Figure 4)
1. Remove the lower and loosen the upper wing
knobs on the handlebar assembly.
2. Loosen the wing nuts on the shift rod.
3. Put the speed selector lever in the first forward
position.
4. Rotate the handlebars into operating position.
5. Install and tighten all wing knobs and wing nuts
on the handlebar assembly and shift rod.
NOTE: The handlebar has two height positions. Adjust
the handlebar height to provide better operator
comfort. See Handlebar Height on page 19.
5
4
1
2, 3
1. Wing Knobs
2. Wing Nut
3. Bolt
Figure 4
1
4. Shift Rod
5. Speed Selector
Lever
OS7030
Install Discharge Chute and Discharge Chute
Crank
(Figure 5)
1. Grease underside of discharge chute ring (if not
already greased).
2. Remove mounting hardware from auger housing.
3. Install discharge chute over opening in the auger
housing. Finger tighten the mounting hardware
removed in step 2.
NOTE: Leave discharge chute pedestal loose to help
install the chute rod and connect it to the control
assembly.
1. Mounting Hardware
2. Discharge Chute
3. Chute Pedestal
GB - 7
1
2
3
4
1
4. Discharge Chute
Ring
Figure 5
OS7040
OS7045