Advertisement
Quick Links
WALL MOUNT
WORK STAND
Sku: 537br130
Space doesn't have to be a limiting
factor when it comes to making a DIY,
public-use bicycle repair area. The Wall
Mount Work Stand is a super tough,
wall-mounted option for providing
access to the most commonly used
bicycle repair tools. When paired with
a manual or Electric Pump, you've got a
area that cyclists will love!
Product Specifications
•
Optional galvanized Wall Plate to protect the wall from tool
strikes and meets ADA compliance
•
Designed for Indoor or Outdoor use
•
Wall mount design; small footprint is perfect for small spaces
•
Pairs perfectly with manual or Electric Public Bike Pump
•
Tools securely attached by braided stainless steel cables
Advertisement
Related Manuals for PARK WAREHOUSE 537br130
Summary of Contents for PARK WAREHOUSE 537br130
- Page 1 WALL MOUNT WORK STAND Sku: 537br130 Space doesn’t have to be a limiting Product Specifications factor when it comes to making a DIY, public-use bicycle repair area. The Wall • Optional galvanized Wall Plate to protect the wall from tool...
- Page 2 8/10mm cone wrench • 9/11mm cone wrench • Torx T-25 • Hex key set Dimensions Model # Description Type of Mount Weight Length Width Height Space Requirement 537br130 Wall Mount Work Stand Wall Mount 29 lbs. 16” 11” 61” See Setback...
-
Page 3: Tools Needed
Tools Needed Recommended Setbacks: Drill and drill bits (mounting hard- See Figure 1 below for minimum space requirements. It is possible to ware dependent) mount a manual or electric pump within this setback region as well. Phillips Screwdriver Mounting Hardware (location dependent) Penta Nut Socket (included) 3/8”... -
Page 4: Wall Mounting Instructions
Wall Mounting Instructions 1. Identify mounting location and be sure to follow recommended setbacks. The top of the work stand should be mounted at 62” (157.5cm) from the ground. If installing on a vending machine, mount in a position that does not inhibit the door opening (we usually mount on the left side of the machine). - Page 5 3. Once the back plate is secured, load the tools to the front cover as shown.
- Page 6 4. Lift the front cover onto the back plate so that the tabs fit into the slots. 5. Install and tighten penta nuts to approximately 5-6 Nm. Be careful not to over tighten.
- Page 7 Optional ADA compliance wall plate For some locations, it may be necessary to install the optional ADA compliance wall plate. This plate also protects the wall from tool damage. 1. Locate the wall plate directly below the work stand at a distance of 1” (2.54cm) off the floor. 2.
- Page 8 WARNING: Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or loss, whether direct, indirect, or incidental, resulting from the incorrect attachment or inappropriate placement, improper use, inadequate maintenance, or neglect of this product. Placement of this product is beyond control of the manufacturer. It is the end users reasonability to place this product so as to avoid potential pedestrian or playground accidents.