Advertisement
5. TROUBLESHOOTING
PROBLEM
Alarm buzzer sounds.
RoadStart has been charging for 20 hours or more and there is no
change in the charge level.
Charge meter reads low, but when the AC adaptor is plugged in the
needle flicks to the right.
RoadStart is fully charged but has no output.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to: www.sealey.co.uk,
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted and
taken to a recycle centre for disposal of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
NOTE: The RoadStart battery is a sealed, lead-acid type. By law, it must be removed and recycled, or disposed of properly,
according to national and/or local regulations.
1.
Place the RoadStart unit front side down.
2.
Remove the screws from the rear panel and lift off from the unit enclosure.
3.
disconnect the wires from the two battery terminals, taking care to avoid accidental arcing of the terminals.
4.
Lift the batteries out of the casing.
Disposal
Take the battery to a recycling centre that handles sealed, lead-acid batteries.
If there is no recycling centre in the area, contact the local environmental agency for disposal instructions.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Ltd
email: sales@sealey.co.uk or phone: 01284 757500.
Environmental Protection
Battery Removal
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
Check for cross connection and rectify.
Check charger to verify if it is charging.The charger should be warm if
operating correctly. Check all connections.
The internal battery of the RoadStart needs to be replaced.
Check the connection between the cables and clamps. Ensure that
they are tight and free from corrosion. Clean and re-crimp if
neccesary.
01284 757500
01284 703534
POSSIBLE SOLUTION
www.sealey.co.uk
sales@sealey.co.uk
RS125.V3
Issue: 1- 15/01/16
Advertisement
