Table of Contents
Advertisement
Front of the device
STANDBY/ON
To switch off or on, interrupt a
function.
PROGRAMME+
PROGRAMME-
programme number. During normal playback, press to
adjust the tracking.
RECORD
To record the TV channel selected at this
moments.
1
When tape playback is stopped, press to fast
forward the tape at high speed. During playback, press to
fast forward the tape while the picture stay on the screen.
2. Important notes for operation
Navigation in the screen menu
You can check/change many functions and set-
tings of your video recorder via the on-screen
menu. The individual functions are selected via
the remote control, as follows:
MENU
Call up the menu: with
To select: with
K B
L C
To enter or change your selection: with the
number buttons
or with
0..9
To save or confirm: with
To cancel: with
.
CLEAR
To end: with
STATUS/EXIT
SELECT K L CHOOSE B
→TIMER
VCR SET UP
TUNER SET UP
INITIAL SET UP
END=EXIT
Switching on
You can switch on the video recorder with the
Automatic switch-off
If the video recorder is not used for several minutes, it switches itself off automatically. This function
can be deactivated (e.g. if you want to use the video recorder as a TV receiver). For more
information, please read the section 'Automatic switch-off' in chapter 'Other functions'.
Time in the display
If you have switched the video recorder off with
'18:00'.
If the clock has not been set, ' --:-- ' will appear.
Power consumption
The video recorder should always be connected to the mains so as not to affect the use of the TV or
programmed recordings.
Your video recorder uses less than 4W.
Power outage/no power
Channel information remains saved for up to 10 year, the time and timer information is saved for up
to 1 minute.
To select the
.
.
.
K B
L C
.
B 1
.
STANDBY/ON y y
STANDBY/ON y y
3
0
When tape playback is stopped, press to rewind
the tape at hight speed. During playback, press to
rewind the tape while the picture stay on the screen.
B
To play a tape.
C /A A
To stop the tape and eject the cassette.
STILL
To stop the tape (still picture).
COUNTER RESET
To reset the counter.
Back of the set
To connect a satellite receiver,
AV2(DECODER)
decoder, video recorder,etc.
AV1(TV)
To connect the TV set(programme number).
AERIAL
To connect the aerial cable.
RF OUT
To connect the TV set.
The symbols on your video recorder
display
These symbols can light up on your video
recorder display:
PWR.
When you keep your video recorder on.
When you have put a cassette in the video
recorder.
Display of programme number of the TV
channel / time / RF channel.
When you record.
When you have programmed a recording.
button.
, the time will show in the display, e.g.
REC
EN
Advertisement
Table of Contents
