Panasonic DH-6SM1PW Operating And Installation Instructions page 9

Note:
• For same level holes, use suitable tool to ensure the hole levelness.
Make 4 holes for Wall Hook at the wall by means of
a drill. Drive the Wall Plug into each hole.
Insert the Flexible Cord to the appliance through Figure 3 as shown below:
• Cutting the Fitting Rubber which is attached to the Back Plate, and pass the Flexible Cord through it.
CAUTION
Mount the appliance on the wall with 4 Screws.
Drive each Screw into the two upper Wall Plugs through the
screw holes on the Back Plate.
After tighten up the two upper Screws, tighten up the remaining
two Screws.
Ensure the set fi xed tightly on the wall by shaking it left and right.
Note:
• The Back Plate must be mounted with 4 Screws.
4. Electric wiring.
• Make sure rated electrical supply is supplied to this appliance.
WARNING
Lead the Flexible Cord connected to ELB terminal
inside the appliance:
Flexible Cord 4.0 mm
DH-6SM1_PH.indb 9 DH-6SM1_PH.indb 9
Figure 3
Flexible Cord must enter the appliance through designated
point only (do not make additional holes).
Proper size of Flexible Cord and electric wiring must be
installed to avoid smoke emission and fi re hazards.
The appliance must be permanently connected to the
electric supply through the ON/OFF DP (double pole) Switch
having a contact separation of at least 3 mm in all poles
incorporated in the fi xed wiring. This switch must be clearly
identifi able but out of reach of a person using a fi xed bath or
shower.
2 , double-coated cable.
25 mm
Ø6 mm
Flexible Cord
Fitting Rubber
Wall Plug
Wall
Wall Plug
Wall
Flexible Cord
FILTER
CLEANING
Wall Plug
Back Plate
Back Plate
Earth
ON/OFF DP
(double pole) Switch
Miniature Circuit
Breaker (MCB)
EN9
1/27/2021 12:55:05 PM 1/27/2021 12:55:05 PM