West Bend 40053 - Electronic Triple Timer/Clock Manual

OPERATING PRECAUTIONS

To prevent personal injury, NEVER place the battery in mouth for ANY reason, as it small and can be swallowed.
DISCARD USED BATTERY IMMEDIATELY. KEEP BATTERY AWAY FROM CHILDREN.

For household use ONLY.

Battery Installation

1. Press down on the clip to expose the battery compartment cover. Slide the battery compartment cover off and insert one triple A (AAA) battery. Be sure to match the plus (+) and minus (-) symbols.
2. Replace the battery compartment cover, peel the static label from the electronic display and your timer is now ready to use.
   Note: The timer will count up to or down from 99 hours, 59 minutes, and 59 seconds. Keep the timer away from all heat sources. Temperatures above 120°F, 50°C, can damage the timer. Never immerse the timer in water or any other liquid.
3. The clip on the back can be attached to any thin surface or belt or can be used with the metal stand bar to stand on any flat surface. The magnet will also secure it to any magnetic surface. Place a lanyard through the hole to hang.

Setting the Clock

1. Press and hold the "CLOCK" button for 5 seconds. The display will flash.
2. Press the "HOUR," "MINUTE," and "SECOND" buttons to advance to the correct time. Holding the buttons down will cause the numbers to advance rapidly.
3. Press the "CLOCK" button once more to activate the clock.

Timer Operation

1. To set the desired time, press "TIME 1," "TIME 2," or "TIME 3" for the desired timer channel. The selected timer channel symbol; T1, T2, or T3, will display.
2. Press "CLEAR" to zero the display.
3. Press and hold the "HOUR," "MINUTE," and "SECOND" buttons to advance to the correct time.
4. Press the "START/STOP/MEMORY" button to begin timing.
5. When time expires, a distinctive alarm will sound. The timer will continue to count up. The alarm will silence after 1 minute.
6. Press any button to silence the alarm, then "START/STOP/MEMORY" to stop the timer.
7. Press "CLEAR" to zero the display.

Recall Previous Time

When the countdown time has expired, press "START/STOP/MEMORY" once to pause the timer, twice to recall previous time, and again to start the countdown timer.

Operate Stopwatch

1. Press "TIME1," "TIME2," or "TIME3" button for the desired timer channel. The selected timer channel symbol; T1, T2, or T3 will display.
2. Press "START/STOP/MEMORY" to time.
3. To pause the stopwatch, press "START/STOP/MEMORY" once to pause, then press again to resume timing.
4. To clear the stopwatch display, press "START/STOP/MEMORY" to stop timing, then press "CLEAR."

Care and Cleaning

1. Wipe the exterior of the timer with a soft, damp cloth if necessary.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download West Bend 40053 - Electronic Triple Timer/Clock Manual