Table of Contents
Advertisement
5.5 Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid items
such as buttons, coins and fabric fibers clogging the pump
impeller during discharge of washing water. Thus, the water
will be discharged without any problem and the service life
of the pump will extend.
If the machine fails to drain water, the pump filter is clogged.
Filter must be cleaned whenever it is clogged or in every 3
months. Water must be drained off first to clean the pump
filter.
In addition, prior to transporting the machine (e.g., when
moving to another house) and in case of freezing of the
water, water may have to be drained completely.
:
Foreign substances left in the pump filter may
WARNİNG
damage your machine or may cause noise problem.
In order to clean the dirty filter and discharge the water:
1. Unplug the machine to cut off the supply power.
:
Temperature of the water inside the machine
WARNİNG
may rise up to 90 ºC. To avoid burning risk, filter must be
cleaned after the water in the machine cools down.
2. Open the filter cover.
3. Follow the below procedures in order to drain
water.
a. In order to collect the water to flow out of the
filter, place a large vessel in front of the filter.
b. Turn and loosen the pump filter until water starts
to flow (counterclockwise). Fill the flowing water
into the container you have placed in front of
the filter. Always keep a piece of cloth handy to
absorb any spilled water.
c When the water inside the machine is finished,
take out the filter completely by turning it.
15 / 20 EN
4 Clean any residues inside the filter as well as
fibers, if any, around the pump impeller region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close
the filter cap by pressing on the tab. If it is one
piece, seat the tabs in the lower part into their
places first, and then press the upper part to
close.
.
Washing Machine / User's Manual
Advertisement
Table of Contents
