Preparations; Unpacking Machine And Embroidery Unit; Connect To The Power Supply; Packing Machine After Sewing - Singer SE9150 Instruction Manual

PREPARATIONS

Unpacking Machine and Embroidery Unit

After lifting the machine out of the box and removing all packing material and the plastic bag, wipe the machine, particularly around
the needle and needle plate to remove any oil before sewing.
When unpacking the embroidery unit, do not throw away the white styrofoam inside the machine box, as this is designed for storing
the embroidery unit when not in use.
Note: Your sewing machine is adjusted to provide the best stitch result at normal room temperature. Extreme hot and cold tempera-
tures can affect the sewn result.

Connect to the Power Supply

Among the accessories you will find the power cord and the
foot control.
On the bottom right side of the sewing machine, you find the
connecting sockets and the ON/OFF button.
1. Connect the foot control cord to the front socket on the
bottom right side of the machine (A).
2. Connect the power cord to the rear socket on the bottom
right side of the machine (B). Plug the cord into the wall
socket.
3. Press the ON/OFF switch (C) to "I" to turn on power and
light.
Sewing speed is regulated by pressing the foot control. The
maximum sewing speed can be adjusted using the Speed Con-
trol Lever.

Packing Machine after Sewing

1. Switch the main switch off. After switching off, residual
power may still remain in the machine. This may cause
the light to stay on for a few seconds while the power is
consumed. This is normal behavior for an energy efficient
appliance.
2. Unplug the cord from the wall socket and then from the
machine.
3. Wind the cord around the foot control for easy storage.
4. Place all accessories in the accessory tray. Slide the tray on
to the machine around the free arm.
5. Place the foot control and cord in the space above the free
arm.
10 – P reparations
A
For the USA and Canada
This sewing machine has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install the
proper outlet. Do not modify the plug in any way.
C
B