Related Manuals for HARD H1942-CGP
Summary of Contents for HARD H1942-CGP
- Page 1 Revised 2022.1 3.3.2022 The nations #1 manufacturer of hospital cribs HOME CARE STANDARD CRIB CAREGIVER INFORMATION & ASSEMBLY INSTRUCTIONS MODELS H1942-CGP, H1952-KGP, H1973-MGP & H1982-YGP 1-800-873-4273 ~ parts@hardmfg.com...
- Page 2 The weight limit of any of the cribs or beds made by Hard Manufacturing is 150lbs. If the weight limit of the bed is exceeded, the additional weight could cause damage to the bed components that could lead to expensive repairs and/or make the bed unsafe for daily use for the patient as a result.
- Page 3 SIDE RAIL OPERATION & SAFETY Crib rails are raised and lowered with a Johns Hopkins Handle on models H1942-CGP, H1952-KGP and H1973-MGP. On model H1982-YPG, the rails have fi ngertip release mechansisms. Johns Hopkins handle Fingertip release The side rail or end rails have “trigger” mechanisms that must lock into place to hold up the rail safely.
- Page 4 CRANK HANDLE USAGE The Head Crank Handle Standard Cribs are equipped with a crank handle for head elevation and it is located on the left side of the foot end. The head crank handle should be tucked in when not in use to help avoid damage from it hitting or getting caught on other objects when the bed is being moved.
- Page 5 HARDWARE IDENTIFICATION FOR CRIB ASSEMBLY Our home care Standard Cribs come packed in 3 large boxes on a pallet. One box contains the mattress, a second box contains the mattress platform, and the last box contains the crib ends, side rails, slide rods and all hardware. If the crib is ordered with an IV Pole, it will be in the box with the ends.
- Page 6 ASSEMBLY INSTRUCTIONS 1. First, attach the mattress platform to the end assemblies by anchoring it into the corner locks on the ends. End Assembly End Assembly Mattress Platform Corner Locks To fi rmly seat the mattress platform into the corner locks, tap the four corners of the platform with the rubber mallet, being careful not to bend or damage the platform or metal pans of the mattress surface.
- Page 7 ASSEMBLY INSTRUCTIONS CONTINUED 3. Take one side assembly with the slide rods inserted making sure the Johns Hopkins handle is facing outwards, and add a plastic spacer, nylon washer, bumper spring and a second nylon washer to the bottom of the slide rods as shown. While holding the hardware in place, lift the side assembly and place the slide rods onto the lower crib eyes as shown.
- Page 8 The nations #1 manufacturer of hospital cribs CAUTION SHEET All bolts and other fasteners must be securely tightened and maintained when crib is put in service. Before each usage or assembly, inspect crib for damaged hardware, loose joints, missing parts or sharp edges. 1-800-873-4273 ~ parts@hardmfg.com...
- Page 9 (1) year from the date of purchase at our discretion. Electrical Components HARD Manufacturing will replace at no cost to the purchaser any motor, staff control or under bed control box found to be defective within two (2) years from the date of purchase at our discretion We recommend the bed be used with a surge protector rated at 400 or more joules;...