Radxa ROCK 3C User Manual 2 Introduction Radxa ROCK 3C is a Single Board Computer (SBC) in an ultra‑small form factor that offers class‑leading performance while leveraging outstanding mechanical compatibility. Radxa ROCK 3C offers makers, IoT enthusiasts, hobbyists, PC DIY enthusiasts and others a reliable and extremely capable platform for building and tinkering their ideas into reality.
・ Hardware access/control library for Linux/Android 4 Electrical Specification 4.1 Power Requirements Radxa ROCK 3C can only be powered by +5V. ・ USB Type‑C® 5V ・ 5V Power from the GPIO PIN 2 & 4 The recommended power source capacity is at least 5V/3A without M.2 SSD or 5V/4A using with M.2 SSD.
I2S3_SDI_M0 GPIO3_A5 I2S3_SDO_M0 5.2 eMMC Module Connector ROCK 3C offers a high speed eMMC socket for eMMC modules which can be used for OS and data storage. The eMMC socket is compatible with readily available industrial pinout and Radxa Computer...
32 Ohm headphones directly. The headphone jack also supports a mic line input. 5.7 M.2 Connector Radxa ROCK 3C offers a M.2 M‑Key 2230 connector with PCIe 2.1 1‑lane and SATA 3.0 combo interfaces, providing high speed storage access. The M.2 M‑Key can be configured either to support NVMe SSD or SATA devices, an additional adapter board is required for SATA support.
85°C peak temperature limiter. 5.9 Fan Connector Radxa ROCK 3C has a 2pin 1.25mm header that enables users to connect to a 5V fan (or other peripheral). The fan can be PWM controlled without speed feedback. 6 Availability Radxa guarantees availability of the ROCK 3C until at least September 2032.
Page 10
The firmware setting is not accessible by the end user. The final end product must be labelled in a visible area with the following: “Contains Transmitter Module 2A3PA-RADXA-ROCK3C” Radxa Computer...
Page 11
For additional hosts other than the specific host originally granted with a limited Radxa Computer...
Page 12
This module complies with FCC RF radiation exposure limits set forth for an Explanation: uncontrolled environment, This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body." This module is designed to comply with the FCC statement, FCC ID:2A3PA-RADXA-ROCK3C Radxa Computer...
Page 13
Information for RF Devices – KDB Publication 784748. Explanation:The host system using this module, should have label in a visible area indicated the following texts: "Contains FCC ID: 2A3PA-RADXA-ROCK3C 2.9 Information on test modes and additional testing requirements Additional guidance for testing host products is given in KDB Publication 996369 D04 Module Integration Guide.
Page 14
Part 15 Subpart B compliance testing with the modular transmitter installed. The host shoule be evaluated by the FCC Subpart B. Explanation: This product uses Chip antenna with a maximum The 2.4G antenna gain is 1.5dBi. 5G antenna gain is 2.3dBi Radxa Computer...