Page 7
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | FIRE RISK HAZARD / DELAYED IGNITION HOT GLASS WILL CAUSE BURNS. High supply pressure will damage the valve / controls. Disconnect the appliance main gas valve/control from DO NOT TOUCH the supply piping when pressure testing that system at GLASS UNTIL COOLED.
Page 9
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER |...
Page 11
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER |...
Page 12
12" Ventilation Ventilation Grills Into Adjoining Room, Grills Into Adjoining Option 2 Room, Remove Option 1 Door into Adjoining Room, Option 12" Ventilated Outlet Attic Outlet To Attic Crawl Space Inlet Ventilated Inlet Air Crawl Space...
Page 13
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER |...
Page 14
10 | Ceiling: 36" Left & Right Sides: 12" Front: 36" Minimum Clearances to Combustible Materials (inches) All Models Front Ceiling Left Right 36” 36” 12” 12” Minimum Firebox Size NG/ Front Rear LP Width Width Depth Height 24” 24” 15”...
Page 15
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 11 Mantel Shelf 12” Heat Resistant 10” Material 8” 6” 4” 2” Heat Resistant Material Top of Fireplace Opening Distances to Underside of Mantel Minimum Clearances to Underside of Mantel (without hood)
12 | Chapter 5: Installation Vented installation Chimney Damper Openings for Vented Operation Free Opening Area of Chimney Damper State and local codes may only for Factory-Built Fireplaces allow operation of this appliance Chimney Appliance input Rating (kBTU/hr) in a vented configuration. Check Height (ft)* your state or local codes.
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 13 installing Gas Supply Apply pipe joint sealant lightly to male 3” Adjustable Bolt threads. This will prevent excess sealant from going into pipe. Excess sealant in NOTICE: A qualified service per- pipe could result in clogged heater valves.
Page 18
14 | Chapter 5: Installation installing Bedrock ii Step 1 Step 4 Burner Clean the fireplace/firebox of any dirt and Unclip and remove the LED light track debris. Provide openings in the fireplace/ that runs above the burner’s gas valve. This firebox for the electrical cord and the inlet will allow you best access for connecting WARNING: Installation...
Page 19
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 15 Step 6 Step 7 Using Six-Foot Power Cord: Feed the Syncing and initializing the power cord through the opening provided Remote System in the fireplace/firebox. Plug the cord into The remote and receiver are synced at the a 110v receptacle.
Page 20
16 | Chapter 5: Installation Step 8 Step 10 Step 11 Grasp the handles on each end of the Wearing protective gloves, pour the 1/2” Test the LED lights. Make sure the case. Lift the case and carefully place the reflective glass media over the top of the power cord is plugged in or a hard- case over the burner assembly.
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 17 Checking Gas Test Pressures Equal To or Less Than Manual 1/2 PSiG Shutoff Connections Open Valve 1. Close manual shutoff valve (see Fig- ure 5.9). WARNING: Test all gas pip- 2.
18 | Chapter 6: Operation operation Multifunction Burner Notes for Remote Operating WARNING: FIRE OR EX- System Remote Operating in- PLOSION HAZARD. Can cause Not all features called out in Figure 6.1 structions property damage, sever injury, are available on this fireplace. or death.
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 19 Temperature indication Turning ON the Burner Remote Flame Control Display, °C or °F With the burner system OFF, press the The ProFlame control has six flame lev- ON/OFF Button on the Remote. A single els.
20 | Chapter 6: Operation Continuous Pilot/intermittent Button Lock Pilot (CPi/iPi) Selection This function will lock the buttons to prevent unintentional or unsupervised During regular operation, the burner sys- operation. tem operates in Intermittent Pilot Mode (IPI). During a prolonged power outage, To turn this function on, press the MODE you can switch the fireplace to operate Button and UP Button at the same time.
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 21 Low Battery Power Detection - Battery Backup Operation Multifunction Burner Remote In case of power loss, the burner will au- tomatically switch to battery mode. The The life span of the remote batteries de-...
Page 26
22 | Chapter 6: Operation LED Lighting Operating instructions Operating LED Lights with Handheld Remote The LED lighting control allows you to have 9 various lighting scenes to switch between as well as an Auto Scene mode that automatically rotates through the 9 different scenes.
Page 27
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 23 Operating LED Lights with Mobile App You can control the LED lighting with the full-function mobile app. Scan the QR code on Figure 6.16 to take you to either Google Play or the App Store to download the app.
Page 28
24 | Chapter 6: Operation INTERMITTENT PILOT INSTRUCTIONS FOR YOUR SAFETY READ BEFORE LIGHTING p WARNING If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. B. Use only your hand to push in or turn the gas A.
Page 29
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 25 DO NOT REMOVE THIS LABEL LINE VOLTAGE TESTED & REPORT NO. See installation & operating instructions for this model. LISTED BY: ANSI-Z21.11.2.2016 Contact local building officials about restrictions and Uncented Room Heater installation specifications in your area.
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 27 Parts List Part Part item Description Number item Description Number 24” Case for Drop-In Burner 02-00119-01 12” Perf Burner Trough (24” Model) 02-00147-01 36” Case for Drop-In Burner 02-00119-02 24”...
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 29 maintenance Cleaning and This appliance and its venting system 5. If your appliance is equipped should be inspected before use and at with a safety barrier, cleaning Maintenance least annually by a qualified service person.
30 | Chapter 10: Troubleshooting troubleshooting WARNING: Turn off the gas WARNING: When servicing WARNING: Do not paint the and electrical power before the control, label all wires prior pilot assembly. servicing the appliance. to disconnection. Wiring errors can cause improper and dan- gerous operation.
Page 35
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 31 OBSERVED FAULT POSSiBLE CAUSE REMEDY Carbon is being deposited on glass media 1. Air shutter is blocked 1. Ensure air shutter opening is free of lint or combustion chamber surfaces.
ODS pilot assemblies carry a original purchaser only. (1) year warranty. WARRANTY CARD Please fill this warrant card and mail it to Grand Canyon Gas Logs to receive a warranty claim Purchased from (Showroom name) ___________________________________________________________________ City _____________________________________________________________ State____________________________ Day/Month/Year ___________________________________________________________________________________...
Page 37
GRAND CANYON GAS LOGS • BED ROCK II VENT-FREE BURNER | 33 DO NOT RETURN TO STORE! STOP, CALL US FIRST For immediate help with installation, product information or if your product arrives damaged, please call our toll free number at:...
Need help?
Do you have a question about the BEDROCK II BURNER VFLDB24L-EN and is the answer not in the manual?
Questions and answers