Table of Contents
Advertisement
Section 3 - Configuration
Select PPPoE (Point to Point Protocol over Ethernet) if your Internet connection requires you to enter a username and password. This information
can be provided by your Internet service provider (ISP). This option is typically used for DSL services.
Username:
Enter the Username provided by your ISP.
Password:
Enter the Password provided by your ISP.
Reconnect
Select either Always on, On demand, or Manual.
Mode:
Maximum Idle
Enter a maximum idle time during which the Internet connection
Time:
is maintained during inactivity. To disable this feature, enable Auto-
reconnect.
Address Mode:
Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address:
Enter the IP Address provided by your ISP (Static IP only).
Service Name:
Enter the ISP Service Name (optional).
Primary DNS
Enter the Primary DNS Server IP address assigned by your ISP.
Server:
Enter the Secondary DNS Server IP address assigned by your ISP.
Secondary DNS
Server:
MTU:
Maximum Transmission Unit - by default this field will be set to Auto.
Select Manual if you need to change the MTU for optimal performance.
Click Save when you are done.
D-Link DIR-822 User Manual
PPPoE
28
Advertisement
Table of Contents
