Table of Contents
Advertisement
2.2 Programming
•
Delete the desired gateway entry from the table at the bottom of the screen:
a.
Note
b.
•
Click LOGOUT to log out from the IP-GW4 Maintenance Utility (see "2.5.2 Log Out").
4.
Click ENTRY.
A maximum of 512 gateway entries can be created.
5.
Click OK.
You will see a confirmation screen.
Note
If your entry contains an invalid value, you will see an error screen. Click OK and try
again with correct values.
6.
Confirm your entry and click OK.
To return to the previous screen, click CANCEL.
Parameter Descriptions
The parameters indicated with "*" must be changed while the VoIP Gateway Card is in the "STOP"
status (see "2.3.1 Status Control"). The changes do not have to be followed by a reboot to become
effective.
GW Entry
The parameters below are used to create gateway entries for both local and remote cards on the
network, as a preliminary step to programming the address translation table (DN2IP).
For a programming example, refer to "4.2.5 Programming the Address Translation Table" of the VoIP
Gateway Card Getting Started.
Note
If you are using a gatekeeper, create the gateway entry only for the local card.
Parameter & Description
*
GW No.
Specifies the number for the gateway entry to be
created.
When changing the current settings of an existing
gateway entry, first delete the gateway entry and then
re-create with new values.
*
Comment
Specifies the comment for the gateway entry.
32
Programming Guide
Select the appropriate check box for the gateway entry you want to delete.
If the gateway entry is registered to a DN2IP entry (see "2.2.7 Address
Translation Table—DN2IP Entry"), no check box will be shown for the gateway
entry.
Click DELETE.
Default
Value Range
0
0 to 511
No default
Max. 16 characters
Advertisement
Table of Contents
