Table of Contents
Advertisement
U
SING THE
STORE THE MONITOR MEMORY
FREQUENCY IN A PERMANENT
CHANNEL
1. Press the PROG button.
2. Press the MEM button.
3. Press the number of the monitor
memory that has the frequency you
want to store.
4. Press the MEM button again.
5. Press the ENT-L/OUT button.
6. Enter the car number using the
number pad.
7. Press the ENT-L/OUT button to lock
in your choice.
LOCKING OUT
If you press ENT-L/OUT while in the
Scan mode, all the frequencies
attached to that car number will be
locked out.
If you press ENT-L/OUT while in
Manual mode, only the frequency
displayed will be locked out.
To unlock one frequency, manually
select the channel. It is stored at and
press the ENT-L/OUT button until L/0
disappears from the display.
To unlock the same car number
channel, manually select the car
number, press and hold the CLEAR
button and press the ENT-L/OUT
button. The car number and LoALLcL
will appear in the display. Press the
ENT-L/OUT button again to unlock the
car number. If you do not want to
unlock the car number, press CLEAR.
S
CANNER
U
SING KEYLOCK
After programming your scanner, you
can eliminate accidental program or
functional changes by locking the
keypad. To turn the Keylock on, press
and hold the
approximately 3 seconds, or until the
scanner beeps three times and
appears in the display. The only usable
buttons while this function is active are
LIGHT, MAN, SCAN,
VOLUME.
To turn the keylock function off, press
and hold the
/ LIGHT button for
approximately 3 seconds until the
scanner beeps three times and
disappears in the display.
U
SING DELAY
Some agencies use two-way radios that
allow for pause between transmissions.
To avoid missing the reply to a query,
your scanner has been equipped with a
DLY/- button that allows you to pause
on a transmission for longer than the
scanner would normally allow.
To activate DELAY while scanning or
searching, press the DLY/• button until
DLY appears in the display. The
scanner will now pause for two
additional seconds before resuming its
scan after the end of the transmission
on that frequency.
To turn off the Delay feature, press
the DLY/• button. DLY will disappear
from the display.
/LIGHT button for
, SQUELCH and
15
Hide quick links:
Advertisement
Table of Contents
