Kingfisher MPS750S-2 Original Instructions Manual page 35

MPS750S-2 / TTPS750
WARNING! Never climb into a tree to prune! Do not stand on ladders, platforms,
logs, or in any position which may cause you to lose your balance or control of
the product! When pruning trees, it is important not to make the flush cut next
to main limb or trunk until you have cut off the limb further out to reduce the
weight! This prevents stripping the bark from the main member!
6. Never stand on a ladder or other type of unstable support while using the product.
Insecure stand invites hazards (Fig. 31).
Fig. 31
WARNING! This product has not been designed to provide protection from
electric shock in the event of contact with overhead electric lines! Therefore do
not use product near cable, electric power or telephone lines. Keep a minimum
distance of 10 m to all electric lines (Fig. 32).
7. Use the product only with secure footing. Hold the product at the right-hand side of
your body. Regularly change the working position and include rest periods during
operation.
8. Do not operate the product with arms fully extended or attempt to cut areas which
are difficult to reach.
9. Keep a firm, steady pressure on the product while working with it. Do not try to force
the product through the wood, let the cutting device do the work, using the gripping
teeth to apply minimal leverage pressure.
10. Beware when reaching the end of the cut. The weight of the product may change
unexpectedly as it cuts free from the wood. Accidents can occur to the legs and feet.
Always remove the product from a wood cut while it is running.
NOTE: The chain must be running at full speed before it comes into contact
with the wood.
3663602627661_MNL_IN_V02.indd 35 3663602627661_MNL_IN_V02.indd 35
Operation
Fig. 32
17-03-2023 16:52:52 17-03-2023 16:52:52
35