Related Manuals for Ocilion IPTV Technologies P510E IP
Summary of Contents for Ocilion IPTV Technologies P510E IP
- Page 1 P510E IP IPTV set-top box Instructions for use Important: Read carefully before use and retain for future reference.
-
Page 2: Table Of Contents
Resetting the remote control..............18 Cleaning....................19 Returning used devices................19 Troubleshooting..................20 10 Legal notes..................... 23 10.1 Registered trademarks and notes on licences........23 10.2 Open Source Software.................. 23 11 Declaration of conformity............... 23 12 Technical specifications................. 24 2 | P510E IP... -
Page 3: Safety Information
Maintain the following minimum clearances around the set-top box: 10 cm above, 5 cm behind, 2 cm on the sides. Never put the set-top box into a cabinet or shelf with insufficient ventilation. P510E IP | 3... - Page 4 The heating of the set-top box is in the permissible range. However, sensitive furniture finishes may become discoloured over time due to ongoing heat exposure. The base can cause discolouration of furniture finishes. Place the set- top box on a suitable underlay if needed. 4 | P510E IP...
-
Page 5: Intended Use
Depending on the configuration of the IPTV system, the set-top box and the operating mode of the remote control. For service use only, or as instructed by your provider. The connection of media can influence the serviceability of the set-top box. P510E IP | 5... -
Page 6: Getting Started
(see markings on the bottom of the battery compartment). 3. Insert the lug of the cover into the opening on the battery compartment and push the battery compartment cover forward until it audibly latches into place. 6 | P510E IP... -
Page 7: Cable Connections
1. Wait until a remote control symbol is displayed on the TV set. 2. Press the button OK to start the automatic detection. 3. The remote control is now paired with the set-top box. Pairing can take a few minutes. P510E IP | 7... -
Page 8: Choosing The Menu Language
Section "Establishing a WiFi connection" on page 8. 5.5.1 Establishing a WiFi connection Various methods are available for establishing a WiFi connection: Search: The set-top box searches for available WiFi networks. Advanced: Use WPS, or enter the SSID manually. 8 | P510E IP... - Page 9 OK. 5. Wait until the connection is established and then press Quit repeatedly until the message Successfully established the network connection. is displayed. Figure 5: WiFi setup Figure 6: Available WiFi networks P510E IP | 9...
- Page 10 Figure 7: Advanced WiFi setup 5.5.2 Checking the WiFi status In the WiFi status: menu, you can access the current data for your WiFi connection such as the signal strength or the MAC address of your WiFi adapter. 10 | P510E IP...
-
Page 11: Software Updates
TV set. This allows you to control the set-top box and your TV set with the remote control. To change the signal type (Bluetooth or infrared), see Section "Changing the signal type" on page 14. P510E IP | 11... -
Page 12: Button Functions
6.1 Button functions Figure 9: Button functions 12 | P510E IP... - Page 13 Stop (recorder/replay/video on demand) Page up/down Current programme (TV guide) Show programme Open stream settings Show quick guide Turn screen off (radio) Show programme details Show list of favourites Delete character Go to previous stream Show help P510E IP | 13...
-
Page 14: Changing The Signal Type
Manual programming: you need to enter the TV code manually. Brand code search: you can search for the desired TV code within a brand. Automatic code search: you can search the entire TV database for a suitable TV code. 14 | P510E IP... - Page 15 If the TV set does not respond to the command, complete steps 2 through 4 using other codes from the TV code list until the TV set turns off. 5. Switch the TV set on again and repeat step 4 to try other buttons, checking whether they work correctly. P510E IP | 15...
- Page 16 4. Press the button to confirm the TV code. The red LED flashes twice in quick succession. Brand Code Brand Code Samsung Loewe Grundig Sony Sharp Philips Toshiba Panasonic Table 2: Brand codes 16 | P510E IP...
-
Page 17: Controlling The Tv
TV. After programming a valid code, you can control your TV set. Press and hold the button, and then press the desired button to control your TV set. P510E IP | 17... -
Page 18: Unpairing The Remote Control (Bluetooth Mode)
If the green LED flashes twice in quick succession, the remote control has been reset to the factory settings. The remote control is in Bluetooth mode. The Bluetooth connection to the set-top box and the programmed TV code (if any) have been erased. 18 | P510E IP... -
Page 19: Cleaning
Reusing materials and recycling used devices makes an important contribution to protecting our environment. To facilitate the disposal of used devices containing batteries, the batteries have to be removed before the devices are brought to a public collection centre. P510E IP | 19... -
Page 20: Troubleshooting
Check if the set-top box is unable to establish a connected to the mains connection to the set-top network. If the problem box. persists, you have to pair the remote control again (see Section "Pairing the remote control" on page 20 | P510E IP... - Page 21 (see Section "Pairing the remote control" on page No picture No mains connection. Check that the power supply unit and cable are properly connected. Defective cable Check cable connections connection. to make sure they are tight. P510E IP | 21...
- Page 22 15 minutes. was performed This may take up to 15 minutes. Table 3: Troubleshooting In case of further issues, contact your network operator. 22 | P510E IP...
-
Page 23: Legal Notes
2014/53/EU - RED Directive 2009/125/EG - Ecodesign Directive 2011/65/EU - RoHS Directive The full text of the EU Declaration of Conformity is available at www.ocilion.com/ce P510E IP | 23... -
Page 24: Technical Specifications
Bluetooth Infrared 36 KHz (RC-5:SAT2 / r-Step) Wifi Wi-Fi 6E (2,4 / 5 / 6 GHz) Wifi security WPA / WPA2 PSK Copy protection Verimatrix Viewright HDMI HDCP 2.3 ® Table 4: Technische Daten set-top box 24 | P510E IP... - Page 25 Environmental conditions Temperature +5 - +40 °C Humidity 20 - 80 % Details of the radio standard Frequency band 2,402 - 2,480 GHz Max. transmitter power 1 mW Table 6: Technical specifications of the remote control P510E IP | 25...
- Page 26 Notes P510E IP | 26...
- Page 27 Notes P510E IP | 27...
- Page 28 Version 2.5 Date 2023-07-06 Hersteller: Ocilion IPTV Technologies GmbH Schärdinger Straße 35 • 4910 Ried im Innkreis / / AUSTRIA Telefon: +43 7752 2144-0 • Internet: www.ocilion.com In the course of product improvements, we reserve the right to make technical and visual changes to the devices described in these instructions for use.