Table of Contents
Advertisement
1.1.7
Internal connectors
1.
Intel
SATA 6 Gb/s connectors (7-pin SATA6G_1~6)
®
These connectors connect to SATA 6 Gb/s hard disk drives via SATA 6 Gb/s signal
cables.
If you installed SATA hard disk drives, you can create a RAID 0, 1, 5, and 10
configuration with the Intel
TUF Z370-PLUS GAMING II Intel
•
•
2.
Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
TUF Z370-PLUS GAMING II Digital Audio connector
The S/PDIF module is purchased separately.
1-10
Rapid Storage Technology.
®
These connectors are set to [AHCI Mode] by default. If you intend to create a Serial
ATA RAID set using these connectors, set the SATA Mode item in the BIOS to [Intel
RST Premium With Intel Optane System Acceleration (RAID)].
Before creating a RAID set, refer to the manual bundled in the motherboard support
DVD.
SATA6G_3
SATA6G_4
SATA6G_6
SATA6G_1
SATA6G_2
SATA6G_5
SATA 6 Gb/s connectors
®
SPDIF_OUT
Chapter 1: Product Introduction
Advertisement
Table of Contents
