Table of Contents
Advertisement
E
O
MERGENCY
PERATION
Press and hold the key programmed as Emergency to enter Emergency Mode.
• The transceiver will beep unless your dealer has activated "Secret" Emergency Mode.
• The channel will switch to the pre-programmed emergency channel.
While in "Secret" Emergency Mode, the Busy indicator lights every 10 seconds.
When your signal has been acknowledged, the Busy indicator will light 2 times
every 10 seconds.
When the transceiver receives an Emergency Reset code, it will return to normal
operation. Or, if you press and hold the Emergency key for more than 10
seconds, you can return the transceiver to normal operation.
If enabled by your dealer, the transceiver can remain in Emergency Mode even
while the transceiver power is OFF.
K
L
EY
OCK
Press the key programmed as Key Lock to lock the keys of the transceiver.
Locking the transceiver keys prevents you from accidentally changing the
channel and channel settings. While key lock is active, you can still use the
microphone PTT switch, the
and
keys.
Press the Key Lock key again to turn this function OFF.
B
/ E
T
EGINNING
ND OF
Your dealer can enable or disable the Beginning/ End of Transmission
identification signals. These signals are used to access and release some
repeaters and telephone systems.
A Beginning of Transmission ID Signal is sent when you press the PTT switch.
An End of Transmission ID Signal is sent when you release the PTT switch.
TK-7102H E 01-11
(power) switch, and the Emergency, Monitor,
ID S
RANSMISSION
IGNAL
11
,
02.9.30, 1:42 PM
11
Advertisement
Table of Contents
