RCA DSA112NW Installer's Manual page 37

Testing the System
3. Tighten the bolts on the foot so that the mast will not rotate.
4. Secure the mounting foot to the temporary stand. Try using
clamps, lag bolts, or a helper to hold the mast foot in place.
5. Place the dish assembly on the mast.
6. Make sure you have a length of RG-6 coaxial cable that will
reach from the temporary dish setup to your DSS
7. Separate the messenger (ground) wire from the RG-6 coaxial
cable by peeling it back; then push the coaxial cable through
the bottom of the mast and out the top.
Pull about three (3) feet of cable out of the top. Loop the
cable and push it through the LNB support arm.
5
® receiver.
7
mast
RG-6 Coaxial
Cable
Messenger (Ground) Wire
35