Using The Remote To Control A Device; Modes Of Operation - RCA DRD460RE User Manual

Using the Remote
Using Direct Entry
1. Turn on the device to be programmed.
2. Look up the brand and code number(s) for the device on the code
list at the end of this section.
3. On your remote control, press and hold the device button you want
to program.
4. Enter a code from the code list.
5. Release the device button, and then press ON•OFF to see if the
device responds to the remote control commands. If it doesn't, try
pressing the device button and then ON•OFF again.
6. If you get no response, repeat these steps using the next code listed
for your brand, until the device responds to the remote control
commands.

Using the Remote to Control a Device

Once the remote has been programmed successfully, you are ready to
use it to control your devices.
To operate the device:
1. Press the device button (TV, VCR, DIRECTV, VCR2, or AUX) to set the
remote to control the device.
2. Press ON•OFF to turn the device on or off.
3. Use the remote control buttons that apply to that device.
• If your remote is programmed to control a VCR, you only need to
press the RECORD button to begin recording from video.

Modes of Operation

Because this universal remote can control several different devices (DVD
player, VCR, cable box, etc.) it uses operational modes triggered by the
device buttons. For example, if you wanted the remote to control the
TV, you would press the TV button to put the remote into TV mode.
Then, if you want to play a videotape press VCR then PLAY (pointing the
remote at the VCR).
This remote control may not operate all
models of the brands that are shown. Use
the codes shown in this manual, or on
the sheet packed with your remote.
21