Dish Pointing; Selecting Dish Type - RCA DRD460RE User Manual

The Menu System

Dish Pointing

The Dish Pointing menu helps you set up your digital satellite receiver
and optimize your reception of the satellite signal.

Selecting Dish Type

It is important to complete each of the following steps required for your
satellite dish antenna. If you do not, you will not receive proper dish
pointing coordinates and will not be able to take full advantage of your
DIRECTV PLUS™ System.
Specify the type of dish you are using:
1. Press MENU on the remote control to bring up the Main menu.
2. Use the arrow buttons on the remote control to highlight Dish
Pointing, then press OK to access the dish pointing screen.
3. Use the arrows to highlight Select Dish, then press OK.
4. Specify the type of dish you are using: a round satellite dish or an
oval satellite dish.
Depending on the type of dish you have, the Select Dish
menu will prompt you for more information about your
satellite dish antenna.
5. If you are using a round satellite dish, you are finished selecting
your dish. Proceed to "Find Your Dish Pointing Coordinates," next in
this book, for further dish pointing instruction.
If you are using an oval satellite dish, you need to complete the next
steps. Select the Next button to continue.
6. Specify the number of satellite locations from which your satellite
dish antenna will be receiving signals. This number is equal to the
number of LNBs (Low Noise Block) mounted on your dish. For
example, if you have two LNBs, select 2 Satellite Location Dish.
7. Select Done and proceed to "Find Your Dish Pointing Coordinates,"
next in this book.
64
Dish Pointing shows you your the current settings
for your satellite dish antenna.
It is important to select the correct dish
type. If you do not, you will not receive
the proper dish pointing coordinates and
you will not be able to take full
advantage of your DIRECTV System.
LNBs
An oval satellite dish with two LNBs
(not provided with all systems).