LAON TECHNOLOGY LTWI-BS250 Quick Reference

LT250
WIRELESS INTERCOM BASIC SYSTEM QUICK REFERENCE
1 MAY 2016 Rev. 2.5
1 3
15
2 4
1. Headset TALK button with indicator light
2. Headset communication group button
3. AUX IN, AUX IN/OUT button with indicator light
4. AUX IN, AUX IN/OUT communication group button
5. RF ALERT indicator light
6. Remote Base Station LINK Indicator light
7. Remote Base Station ACTIVE indicator light
8. Headset speaker volume control (UP) / Menu selection button
9. Headset speaker volume control (DOWN) / Menu Selection button
10. Menu selection button (LEFT)
11. Menu selection button (RIGHT)
12. Menu SET button
13. Headset cable connector (Receptacle)
14. Hands Free/PTT mode selection button
15. OLED Display
2
1
3
5
6
4
7
8
Front and rear panel of the Belt Pack, LTWI-BP250
BASE STATION DISPLAY MENU
<MAIN Menu>
<VOLUME Menu>
<UNLATCH Menu>
<BELTPACK>
<MONITOR Menu>
<RBS Menu>
<BS Menu>
▣ Pressing SET for 2 seconds on any menus will lead you to the NORMAL menu.
5
6 8 12 13
7 14 10 9
11
9
10
11
<NORMAL Menu>
Press SET to move from
NORMAL to MAIN menu
Use UP/DOWN/LEFT/RIGHT
button to move
<LABEL/GROUP/PAIR Menu>
<RESET Menu>
LTWI-BS250 BASE STATION CONTROLS AND CONNECTIONS
1
2 3
Rear panel of the Base Station, LTWI-BS250
1. Antenna connector
2. AUX IN connector
3. AUX OUT connector
4. Power switch
5. Antenna connector
6. 8-OHM speaker 2-pin spring clamp connector
7. USB connector
8. LAN RJ-45 connector
9. POWER connector
10. Wall-mount bracket holder (bottom)
LTWI-BP250 BELT PACK CONTROLS AND CONNECTIONS
1. Headset cable connector
2. OLED display
3. Headset TALK button with indicator light
4. Power (PWR) button
5. Headset communication group (GRP) button
6. Headset speaker volume control (UP) /
Menu selection button
7. Menu SET button
8. Headset speaker volume control (DOWN) /
Menu selection button
9. Belt clipper
10. Battery cover
11. Charger terminals (Bottom)
BELT PACK DISPLAY MENU
▣ Pressing PWR button slightly on any menus will lead you to the NORMAL menu.
VOICE MESSAGES
to move
Base Station:
one/two/three", "Group all"
"Power on", "Power off", "Hands free on", "Hands
Belt Pack:
free off", "Beep", "Maximum","Minimum", "Audio channel is
busy", "Unlatched", "Change battery", "Out of coverage"
"Group one", Group two", "Group three"
5
4
7 9 10
6 8
<NORMAL Menu>
Press SET to move from NORMAL to MAIN menu
<MAIN Menu>
Use UP/DOWN button to move
<HANDS FREE on/off>
<SPAKER volume>
<MICROPHONE gain>
<TWO GROUPS>
<HANDSOFF SENSIBILITY>
"Beep", "Maximum", "Minimum", "Group
1