Setup - Graco LazerVac 25R090 Operation - Repair - Parts

Setup

Setup
1. Install dust collection bags onto vacuum and into
separator.
a. Slide the Vacuum Dust Collection Bag onto the
Continuous Dust Bag Adapter. Install the bag
assembly onto the bottom of the Main Housing
of the LazerVac. Wrap the Velcro Belt around
the top of the bag to ensure an air tight seal.
Pull enough bag down to rest on the bottom of
the vacuum cart, then tie a cable tie around the
bottom of the bag.
b. If using a Cyclone separator, remove the
Separator Lid and insert the Dust Bag into the
tank. Insert the Dust Bag Holder into the bag.
Wrap the bag around the lip of the tank and
reinstall the Separator Lid onto the tank.
6
2. Connect hoses.
If using a Cyclone separator:
• Connect one end of the Short Vacuum Hose to the
inlet of the LazerVac. Connect the other end of the
Short Vacuum Hose to the outlet of the Cyclone
separator.
• Connect one end of the Long Vacuum Hose to the
inlet of the Cyclone separator. Connect the other
end of the Long Vacuum Hose to the vacuum
hookup on the GrindLazer.
If not using a Cyclone separator:
• Connect one end of the Long Vacuum Hose to the
inlet of the LazerVac. Connect the other end of the
Long Vacuum Hose to the vacuum hookup on the
GrindLazer.
NOTE: Use the Y-Connector to connect 2 hoses to the
vacuum or separator, if desired.
3A5577D