Cleaning Exterior Plastic, Rubber And - Volvo V60 2019 Owner's Manual

MAINTENANCE AND SERVICE
Cleaning wheel rims (p. 619)
•
Rustproofing (p. 619)
•
618

Cleaning exterior plastic, rubber and

trim components
The car should be washed as soon as it
becomes dirty. This means that the car is easier
to clean since the dirt does not attach as firmly.
It also reduces the risk of scratches and keeps
the car fresh. Carry out cleaning in a cleaning
area with an oil separator, and use car shampoo.
Exterior plastic, rubber and trim
components
A special cleaning agent available from Volvo
dealers is recommended for the cleaning and
care of coloured plastic parts, rubber and trim
components, e.g. glossy trim mouldings. When
using such a cleaning agent the instructions
must be followed carefully.
Avoid washing the car with detergent with a pH
value below 3.5 or above 11.5. This can cause
discolouration of anodised aluminium compo-
nents*, as illustrated. We advise against use of
abrasive polishing agents, as illustrated.
Parts that should be washed using a cleaning agent with
a pH value between 3.5 and 11.5.
IMPORTANT
Avoid waxing and polishing on plastic and
rubber.
When using degreasant on plastic and rubber,
only rub with light pressure if it is necessary.
Use a soft washing sponge.
Polishing glossy trim mouldings could wear
away or damage the glossy surface layer.
Polishing agent that contains abrasive must
not be used.
* Option/accessory.